ECMP

Equal-cost multi-path (ECMP) is a routing strategy whereby packets are forwarded along multiple paths of equal cost. Load sharing occurs automatically for IPv4 and IPv6 routes with multiple installed next hops. The hardware or the routing protocol configuration determines the maximum number of routes for which load sharing occurs.

Refer to Cumulus Linux and ECMP for more information about ECMP.

ECMP Commands

Monitor ECMP routing data with the following commands. See the command line reference for additional options, definitions, and examples.

netq show ecmp
netq show ecmp-hash-config

View ECMP Resource Utilization in the UI

You can view resource utilization for ECMP next hops in the full-screen switch card. In the workbench header, select Devices, then click Open a device card. Select a switch from the list. When the card opens on the dashboard, expand it to the largest size.

Select Forwarding resources from the side menu. The ECMP next hops column displays the maximum number of hops seen in the forwarding table, the number used, and the percentage of this usage compared to the maximum number.

Adaptive Routing

Adaptive routing is a load balancing feature that improves network utilization for eligible IP packets by selecting forwarding paths dynamically based on the state of the switch, such as queue occupancy and port utilization. You can use the adaptive routing dashboard to view switches with adaptive routing capabilities, events related to adaptive routing, RoCE settings, and egress queue lengths in the form of histograms.

Requirements

To display adaptive routing data, you must have adaptive routing configured on the switch; it can be either enabled or disabled. Switches without an adaptive routing configuration will not appear in the UI or CLI. Additionally, RoCE lossless mode must be enabled to display adaptive routing data. Switches with RoCE lossy mode enabled will appear in the UI and CLI, but will not display adaptive routing data.

Adaptive Routing Commands

Monitor adaptive routing with the netq show adaptive-routing config commands. The output of these commands display adaptive routing information either globally on the switch or at the interface level.

netq show adaptive-routing config global
netq show adaptive-routing config interface

Access the Adaptive Routing Dashboard

1. Select Menu.

2. Under the Network section, select Adaptive routing.

The adaptive routing dashboard displays:

• Devices with adaptive routing configured (enabled or disabled) and their RoCE modes (lossy or lossless).
• A list of interfaces on the switch and their configurations. In the Interfaces column, select View details to view interfaces with adaptive routing configured:

• A summary of adaptive routing events, including ECMP traffic imbalances:

• A list of up to 10 switches, which can be sorted by highest P95 value, highest standard deviation, or ports with the widest deviation from the P95 value (aggregated over the past 3 minutes). From this panel, you can select View more in the View histogram column to display queue lengths in the form of histograms for any listed switch.